Menu Settings Table - Oki MICROLINE ML521 Product Update

General Information (continued)

Menu Settings Table

Microline 300 Series Printers ONLY
The settings listed below are the changes or additions to those listed in the User's Guide.
For a complete explanation of the menu and each menu item, refer to the User's Guide, "Using Your Printer, Menu Mode,
Explanations of Menu Items."
The User's Guide is provided as an Adobe Acrobat file on the CD provided with your printer.
The table below shows the items that may appear in the menu. Settings which are engaged at the factory (defaults) are set
in bold italic. Some groups or entries will only appear when a specific emulation is engaged, as noted.
Group
Symbol Sets Code Page
(ML390/391 Series
printers only)
Top Feed Form Tear-off
Set-Up CSF Bin Select
CSF Type
ESC SI Pitch
Serial I/F Serial I/F only appears when an optional Serial Interface board is installed.
Parity
Serial Data 7/8 Bits
Protocol
Diagnostic Test
BusyLine
Baud Rate
DSR Signal
DTR Signal
Busy Time
CSF Bin 1 CSF Bin 1 only appears when an optional Cut Sheet Feeder is installed.
Line Spacing
Bottom Margin
Page Width
Page Length
CSF Bin 2 CSF Bin 2 only appears when an optional Dual Bin Cut Sheet Feeder is installed.
Line Spacing
Bottom Margin
Page Length
Page 6 of 20
Menu_Settings_Table.doc
Item
USA, Canada French, Multilingual, Portugal, Norway, BRASCII,
Abicomp, Multilingual 858, ISO 8858-15
Form Tear-off only appears when an optional Roll Paper Stand is
installed.
OFF, 500 ms, 1 sec, 2 sec
CSF Bin Select only appears when an optional Dual Bin Cut Sheet Feeder
is installed.
Bin 1, Bin 2
CSF Type only appears when an optional Cut Sheet Feeder is installed.
Wide, Narrow
17.1 CPI, 20 CPI
None, Odd, Even
8 Bits, 7 Bits
Ready|Busy, X-ON/X-OFF
No, Yes
SSD -, SSD +, DTR, R TS
9600, 4800, 2400, 1200, 600, 300, 38400, or 19200 BPS
38400 BPS is displayed only when an optional serial interface board with
38400 firmware is installed.
Valid, Invalid
Ready on Power Up, Ready on Select
200 ms, 1 sec
6 LPI, 8 LPI
Valid, Invalid
13.6", 8"
The setting for Page Width affects both Bin 1 and Bin 2.
On a wide-carriage printer (321, 391), when Page Width is set to 8", the
printer prints 8" wide lines, not the full width of the printer.
11", 11 2/3", 12", 14", 17", 3.5", 4", 5.5", 6", 7", 8", 8.5"
6 LPI, 8 LPI
Valid, Invalid
11", 11 2/3", 12", 14", 17", 3.5", 4", 5.5", 6", 7", 8", 8.5"
Settings
(Defaults are set in bold italic)
P/N 58356302