5) When the setting is correct, enter [Y]. The system is now registered. If not correct, enter [N]. Then repeat
from step 1) again.
When registering the system, also register ANSI.SYS required for screen control and MOUSE.SYS for using
the mouse.
If RMCS is already set in the IBM PC/AT, RMCS SETTING MENU is displayed as below.
6) When updating, enter [Y]. Then updating status. When not updating, enter [N].
RMCS System
Remote Management Center System
<< RMCS SETTING >>
HARD DISK DRIVE
= [C]
DIRECTORY
= [C:\RMCS_
PASSWORD
= [
DIPSW (ON:0 OFF:1) = [11000000]
Are you sure (Y or N)?
Press the Esc key to cancel.
Remote Management Center System
<< RMCS SETTING >>
"RMCS" system already registered!
Over write OK ?
Y
Press the Esc key to cancel.
G - 7
]
]
Y
Service Manual, P/N 59276801
OKIOFFICE 44