2.2.5 Updating the Dip Switches
This setting is available for only RMCS Model 10.
1) Search the directory in which the system is registered. When the system is found, the dip switch setting is
displayed.
For the detail of setting, refer to 2.2.1.
After setting is completed, press [Enter]. Then the screen for verification is displayed.
3) When the setting is corrected, enter [Y]. The dip switches are now updated. If not correct, enter [N]. Then
repeat from step 1) again.
RMCS System
Remote Management Center System
<< DIP SW UPDATE >>
DIP SW (ON:0 OFF:1) = [11010000]
(For RMCS Model 10 only.)
Press the Esc key to cancel.
Remote Management Center System
<< DIP SW UPDATE >>
DIP SW (ON:0 OFF:1) = [11010000]
Are you sure (Y or N)? Y
Press the Esc key to cancel.
G - 11
OKIOFFICE 44
Service Manual, P/N 59276801