Led Print Head - Oki OKIOFFICE44 Service Manual

4.1.3.1 LED Print Head

Two LED print heads are available.. (208 mm (8.18 inch) width or 216 mm (8.5 inch) width)
(1) Disassembly procedure
a) Open the cover assembly-top by raising
the cover in the direction of the arrow.
b) Disconnect the PC connector from the
LED print head.
c) Remove the LED head while spreading
the left clamp on the cover assembly-top.
Note:
Be sure not to touch directly or push the
SLA part of the print head.
(2) Reassembly procedure
Reverse the disassembly procedures.
Note:
After replacing the LED print head, set
drive time of the LED print head follow-
ing the marking. (Refer to section 5.1).
When you replace the LED print head, if
the width of the LED head to be used is
changed from current version, you should
select the head width by the service
personnel initial setting. (Refer to table
3.9.1 TF No. 27 and 28)
Disassembly
Cover assembly-top
4 - 7
Service Manual, P/N 59276801
(CP4.1 Fig. 03)
LED head
PC Connector
(CP4.1 Fig. 04)
OKIOFFICE 44