4.1.3.15 Heat Assembly
This section explains how to dismount the heat assembly and parts in the assembly.
(1) Disassembly procedure
Dismounting the heat assembly
a) First, carry out procedure up to the point of the
4.1.3.2 (ID Unit, Cover-Rear, Cover-NCU and
Cover-MAIN).
b) Dismount the high-voltage power supply board.
(See Section 4.1.3.10)
c) Remove NCU-Board with two screws.
d) Remove Bracket-Package with three screws, then
disconnect Cable-Flat from connector on R44-
Board (M-CNT).
(See Section 4.1.3.19)
e) Pull out the Holder-Assy. (See Section 4.1.3.11)
f)
Disconnect connector 2, remove two screws 1, and
dismount the heat assembly.
(2) Reassembly procedure
Reverse the disassembly procedures
Disassembly
Screw 1
Connector 2
4 - 24
Service Manual, P/N 59276801
Screw 1
Heat assembly
(CP4.1 Fig. 30)
(CP4.1 Fig. 31)
OKIOFFICE 44