e) Move the left and right paper guides to the center.
Extend the unit two inches beyond the work bench,
to allow for clearance.
Lift (from the rear) the main cover.
f)
Board-NCU:
Remove the Board-NCU by removing the two screw
3 and disconnect the connector (CN3) from Board-
NCU.
Note:Board-NCU can be removed without removing
the Cover-Main.
(2) Reassembly procedure
Reverse the disassembly procedures.
Disassembly
Holder assembly
4 - 9
Service Manual, P/N 59276801
Cover-main
Guide-paper (R)
Guide-paper (L)
(CP4.1 Fig. 08)
Board-NCU
OR
Screw 3
(CP4.1 Fig. 09)
OKIOFFICE 44