4.1.3.19 Printer Unit
(1)
Disassembly procedure
a)
First, carry out procedure up to the point
of the 4.1.3.2 (ID Unit, Cover-Rear,
Cover-NCU and Cover-Main).
b)
Remove Bracket-Package with three
screws, then disconnect Cable-Flat from
connector on R44-Board (M-CNT).
c)
Dismount the high-voltage power supply
board.
(See Section 4.1.3.10)
Disconnect cable 1 and 2 from connector
d)
on Board-R44 (M-CNT), and disconnect
cable 3 from Connect on Power Supply
Unit.
e)
Remove the Printer Unit by removing
three screws.
f)
Detach the four clamps from underneath,
push inward on the top two tabs while
lifting up to remove the Holder-Assy.
Cable 1, 2
Disassembly
Cable-Flat
Holder Assy
Bracket-Package
4 - 28
Cable 3
Printer Unit
OKIOFFICE 44
Service Manual, P/N 59276801
Add