Document Skew - Oki OKIOFFICE44 Service Manual

7.1.20 Document Skew

Start
Are the document guides set to meet the
Are the documents straightly loaded along
The documents have
the same width?
The thickness of the document:
< 0.08 to 0.13 mm (.003 to .005") Multiple doc
< 0.06 to 0.15 mm (.039 to .006") Single doc.
The documents are
normal?
Check points:
1. Adhesive such as paste, tape, etc. on the
surface of the documents?
2. The leading edges of the documents are
rugged due to paste, etc.?
Is the control panel unit firmly closed?
Are there obstacles such as pieces of
paper in the document-passing slot?
Is the document-passing slot rugged
A
Troubleshooting
document width?
the guides?
Yes
No
Yes
Yes
No
Yes (Normal)
Yes
No
due to flaws, etc.?
No
7 - 28
1. Set the guides to meet the
No
document width.
2. Load the documents
straight along the guides.
Load documents by meeting
the same width.
No
Use documents of the left
specification.
Use the carrier sheet.
No
Close the control panel unit.
Yes
Remove the obstacles.
Yes
Replace the rugged parts.
Service Manual, P/N 59276801
OKIOFFICE 44