Drive Shaft E (Eject) And Eject Roller - Oki OKIOFFICE44 Service Manual

4.1.3.14 Drive Shaft E (Eject) and Eject Roller

(1) Disassembly procedure
a) First, carry out procedure up to the point
of the 4.1.3.2 (ID Unit, Cover-Rear, Cover-
NCU and Cover-MAIN).
b) Remove two screws 1 from Cover Heat
Assembly (section 4.3.7), lift the heat
assay, and dismount idle gear E (A) and
idle gear E (B).
c) Unlock and dismount drive shaft E (Eject).
d) Dismount two eject rollers.
(2) Reassembly procedure
Reverse the disassembly procedures.
Disassembly
Drive shaft E (Eject)
Eject roller
Screw 1
4 - 23
Idle gear E (B)
Idle gear E (A)
(CP4.1 Fig. 29)
OKIOFFICE 44
Service Manual, P/N 59276801