Appendix F M320 Router Cable Connector Pinouts; M320 Rj-45 Connector Pinouts For The Routing Engine Ethernet Port; Table 35: Rj-45 Connector Pinouts - Juniper M320 Hardware Manual

APPENDIX F
M320 Router Cable Connector Pinouts

M320 RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
M320 RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port on page 265
M320 RJ-48 Cable Pinouts for E1 and T1 PICs on page 266
M320 RJ-48 Connector Pinouts for the Control Board External Clock Inputs on page 269
M320 DB-9 Connector Pinouts for the Routing Engine AUX and CONSOLE
Ports on page 270
M320 Fast Ethernet 48-port Cable Pinouts on page 271
The port on the CIP labeled
receptacle that accepts an Ethernet cable for connecting the Routing Engine to a
management LAN (or other device that supports out-of-band management). Table 35
on page 265 describes the RJ-45 connector pinouts.

Table 35: RJ-45 Connector Pinouts

Pin Signal
1 TX+
2 TX –
3 RX+
4 Termination network
5 Termination network
6 RX–
7 Termination network
8 Termination network
M320 Chassis Description on page 6
M320 Connector Interface Panel (CIP) Description on page 25
ETHERNET is an autosensing 10/100-Mbps Ethernet RJ-45
265