Installing The M320 Cable Guards; Figure 32: Reinstalling An M320 Power Supply - Juniper M320 Hardware Manual

M320 Router Hardware Guide
Related
Documentation

Installing the M320 Cable Guards

68
Tighten the captive screws on each side of the power supply faceplate to secure the
6.
power supply in the chassis.
Repeat the procedure for the remaining power supplies.
7.

Figure 32: Reinstalling an M320 Power Supply

Preventing Electrostatic Discharge Damage to an M320 Router on page 214
M320 Chassis Lifting Guidelines on page 216
M320 Chassis Description on page 6
M320 Cabinet Size and Clearance Requirements on page 46
M320 Site Preparation Checklist Requirements on page 41
General Safety Guidelines for M Series, MX Series, and T Series Routers on page 211
Maintenance and Operational Safety Warnings for M Series, MX Series, and T Series
Routers on page 225
General Electrical Safety Warnings for M Series, MX Series, and T Series Routers on
page 231
After the chassis is installed in the rack or cabinet, you can install the four cable guards.
The cable guards protect the PIC and CIP cables from rubbing against the front edges
of the chassis.
To install the cable guards (see Figure 33 on page 69):
Place one of the upper cable guards over one of the front-mounting flanges of the
1.
chassis, aligning the top of the cable guard with the top of the flange. Each of the
three captive screws on the guard should be aligned with a corresponding standoff
on the flange.
Tighten each of the three captive screws partway on the cable guard.
2.
Tighten each of the three captive screws completely.
3.
Copyright © 2010, Juniper Networks, Inc.