Figure 113: Typical Dc Source Cabling To The Router - Juniper M320 Hardware Manual

M320 Router Hardware Guide
Related
Documentation
258
the color coding for the leads on the power cables that attach to the terminal
studs on each power supply.
Figure 113 on page 258 shows a typical DC source cabling arrangement.

Figure 113: Typical DC Source Cabling to the Router

WARNING: For field-wiring connections, use copper conductors only.
For other electrical safety information, see "Site Electrical Wiring Guidelines
for M Series, MX Series, and T Series Routers" on page 249.
CAUTION: Power cords and cables must not block access to router
components or drape where people could trip on them.
For a description of the DC power supply, see , as opposed to the DC power configuration
(see "M320 DC Power Supply" on page 34 for more information). For instructions on
connecting the DC power and grounding cables during initial installation, see "Connecting
Power to a DC-Powered M320 Router" on page 97. For instructions on replacing a DC
power cable, see "Replacing an M320 DC Power Supply Cable" on page 202.
M320 Power System Description on page 33
M320 Power Supply LEDs on page 35
M320 Power Requirements on page 250
Copyright © 2010, Juniper Networks, Inc.