Installing A Rear M320 Air Filter; Figure 74: Removing The Rear Air Filter Element - Juniper M320 Hardware Manual

M320 Router Hardware Guide

Figure 74: Removing the Rear Air Filter Element

Installing a Rear M320 Air Filter

152
To install the rear air filter (see Figure 75 on page 153):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Align the filter with the right side of the air filter slot and carefully push the filter all
2.
the way into the slot. The top and bottom air filter guides direct the filter to the left
as it is pushed into the slot.
Holding the filter all the way in, push it to the right side of the slot until it is held in
3.
place behind the hooks.
Place the right edge of the honeycomb against the flange of the air filter slot.
4.
Line up the holes at the top, center, and bottom of the honeycomb with the pins in
5.
the slot and press the honeycomb into place.
Copyright © 2010, Juniper Networks, Inc.