Fire Safety Requirements For M Series, Mx Series, And T Series Routers; General Fire Safety Requirements; Fire Suppression; Figure 109: Placing A Component Into An Electrostatic Bag - Juniper M320 Hardware Manual

Related
Documentation

Fire Safety Requirements for M Series, MX Series, and T Series Routers

General Fire Safety Requirements

Fire Suppression

Copyright © 2010, Juniper Networks, Inc.

Figure 109: Placing a Component into an Electrostatic Bag

M320 Router Description on page 3
General Electrical Safety Warnings for M Series, MX Series, and T Series Routers on
page 231
Installation Safety Warnings for M Series, MX Series, and T Series Routers on page 217
Contacting Customer Support on page 281
General Fire Safety Requirements on page 215
Fire Suppression on page 215
Fire Suppression Equipment on page 216
In the event of a fire emergency involving routers and other network equipment, the safety
of people is the primary concern. Establish procedures for protecting people in the event
of a fire emergency, provide safety training, and properly provision fire-control equipment
and fire extinguishers.
In addition, establish procedures to protect your equipment in the event of a fire
emergency. Juniper Networks products should be installed in an environment suitable
for electronic equipment. We recommend that fire suppression equipment be available
in the event of a fire in the vicinity of the equipment, and that all local fire, safety, and
electrical codes and ordinances be observed when installing and operating your
equipment.
In the event of an electrical hazard or an electrical fire, first turn power off to the equipment
at the source. Then use a Type C fire extinguisher, which uses noncorrosive fire retardants,
to extinguish the fire. For more information about fire extinguishers, see "Fire Suppression
Equipment" on page 216.
Appendix A: M320 Router Safety and Regulatory Compliance Information
215