Connecting Power To A Dc-Powered M320 Router; Providing Power To The M320 Router; Figure 54: Connecting Ac Power To The M320 Router - Juniper M320 Hardware Manual

Related
Documentation

Connecting Power to a DC-Powered M320 Router

Copyright © 2010, Juniper Networks, Inc.
Carefully pull the AC power cord through the cable restraint until you have the desired
9.
amount of slack in the power cord.
Tighten the cable restraint retainer screw to hold the power cord in place.
10.
Insert the power cord plug into an AC power source receptacle. Verify that the power
11.
cord does not block access to router components or drape where people could trip
on it.

Figure 54: Connecting AC Power to the M320 Router

M320 AC Power Supply on page 33
M320 AC Power Electrical Safety Guidelines on page 235
M320 AC Power Electrical Safety Warning on page 235
General Electrical Safety Warnings for M Series, MX Series, and T Series Routers on
page 231
Preventing Electrostatic Discharge Damage to an M320 Router on page 214
You connect DC power to the router by attaching power cables from the DC power sources
to the terminal studs on the power supply faceplates. To connect power to the router,
you must provide grounding and power cables (the cable lugs are supplied with the
router). For grounding and power cable specifications, see "M320 Chassis Grounding
Cable and Lug Specifications" on page 250 and "M320 DC Power Cable Specifications"
on page 257.
Chapter 9: Providing Power to the M320 Router
97