Figure 105: Installing A Dc Power Supply; Figure 106: Connecting Power Cables To The Dc Power Supply - Juniper M320 Hardware Manual

M320 Router Hardware Guide
200
Tighten the cable restraint captive screw to hold the power cables in place.
12.
Verify that the ground and power cabling are correct, that they are not touching or
13.
blocking access to router components, and that they do not drape where people could
trip on them.
Replace the clear plastic cover over the terminal studs on the faceplate.
14.
Switch on the external circuit breakers to provide voltage to the DC power source
15.
cable leads.
Switch the circuit breaker on the power supply faceplate to the on position (
16.
that the status LED on the power supply faceplate blinks, then lights
OUTPUT OK
steadily approximately 1 minute after you switch the power supply circuit breaker on.

Figure 105: Installing a DC Power Supply

Figure 106: Connecting Power Cables to the DC Power Supply

). Verify
|
Copyright © 2010, Juniper Networks, Inc.