Replacing An M320 Dc Power Supply; Figure 102: Installing An Ac Power Supply - Juniper M320 Hardware Manual

M320 Router Hardware Guide

Figure 102: Installing an AC Power Supply

Replacing an M320 DC Power Supply

196
Reinstall the cable restraint by tightening its retainer screw partway into the power
9.
supply faceplate.
Carefully pull the AC power cord through the cable restraint until you have the desired
10.
amount of slack in the power cord.
Tighten the cable restraint retainer screw to hold the power cord in place.
11.
Insert the power cord plug into an AC power source receptacle. Verify that the power
12.
cord does not block access to router components or drape where people could trip
on it.
Switch the powers seitch on the power supply faceplate to the on position (
13.
that the OUTPUT OK status LED on the power supply faceplate blinks, then lights
steadily approximately 1 minute after you switch the power switch on.
Removing an M320 DC Power Supply on page 197
Installing an M320 DC Power Supply on page 199
). Verify
|
Copyright © 2010, Juniper Networks, Inc.