Copyright © 2010, Juniper Networks, Inc.
(
), and the ports labeled
RE0
Engine slot (
).
RE1
Using a 2.5-mm flat-blade screwdriver, tighten the screws on the connector.
3.
Attach the other end of the cable to the console or auxiliary device.
4.
Figure 69: Routing Engine Console or Auxiliary Cable
Connect the other end of the serial cable into the serial port on the console or auxiliary
5.
device.
Replacing the M320 Alarm Relay Wires
To connect the router to external alarm-reporting devices, attach wires to the
relay contacts on the CIP. A system condition that triggers the red or yellow
YELLOW
alarm LED on the craft interface also activates the corresponding alarm relay contact.
Chapter 13: Replacing the M320 Router Hardware Components
connect to the Routing Engine in the lower Routing
HOST 1
RED
and
147