Juniper M320 Hardware Manual page 170

M320 Router Hardware Guide
144
Press the tab on the connector and pull the connector straight out of the
1.
port. Figure 67 on page 145 shows the connector.
Disconnect the cable from the network device.
2.
Plug one end of the replacement cable into the appropriate
3.
labeled connect to the Routing Engine in the upper Routing Engine slot (
HOST 0
and the ports labeled
HOST 1
Engine slot ( RE1 ).
Plug the other end of the cable into the network device.
4.
connect to the Routing Engine in the lower Routing
Copyright © 2010, Juniper Networks, Inc.
ETHERNET
ETHERNET port. The ports
),
RE0