Configuring Advanced Acl Settings - Nortel 2350 Reference Manual

212 Configuring WSS System Parameters
❍
Select the ToS value in the TOS box.
❍
❍
❍
❍
❍
❍
By default, the TOS value is -1 (any).
In addition to these specific values, you can specify a number from 1 to 15 that is the sum of TOS
option values. For example, to select minimum delay and maximum throughput as the TOS options,
type 12, which is the sum of the two values.
d
Click OK.
10 Select the action from the Action drop-down list:
• Permit—allows access if the conditions in the ACE are matched
• Deny—refuses access if the conditions in the ACE are matched
11 To mark the packet with a CoS value, select the value in the CoS box.
Packet Priority
Desired
Background
Best effort
Video
Voice
By default, the CoS value is -1 (any).
12 Repeat
step 3
13 To reorder the ACEs, select an ACE and click the up or down arrow to move it.
14 Click OK to save the ACL. The ACL appears in the ACL table.

Configuring Advanced ACL Settings

After you configure an ACL, you can configure the following advanced settings:
• Hit counter (enable or disable)
• Hit sample rate (applies if the hit counter is enabled)
• Established option, to apply a new TCP ACE only to established (existing) TCP sessions. By default, TCP ACEs
apply to new sessions as well as existing ones.
NN47250-102 (320666-G Version 02.01)
Network Control (7)—Packets with network control precedence are filtered.
-1 (any)—All packets are subject to the ACE regardless of whether TOS is set.
0 (normal)—Packets with normal TOS defined are filtered.
1 (minimum monetary cost)—Packets with minimum monetary cost TOS defined are filtered.
2 (maximum reliability)—Packets with maximum reliability TOS defined are filtered.
4 (maximum throughput)—Packets with maximum throughput TOS defined are filtered.
8 (minimum delay)—Packets with minimum delay TOS defined are filtered.
CoS Value
1 or 2
0 or 3
4 or 5
6 or 7
to step 11 for each ACE.
AP Forwarding
Queue
Assignment
4
3
2
1