Nortel 2350 Reference Manual page 232

232 Configuring Wireless Parameters
9
If you selected RSN or WPA in step 7, you can type a string from 8 to 63 characters long in the Pre-shared
Key box and click Generate.
• To use dynamically generated keys, leave the Pre-shared Key box blank and go to
• To use static keys, type a string from 8 to 63 characters long in the Pre-shared Key box and
click Generate.
10 Click Next.
11 Select the encryption algorithms to use:
• AES (CCMP)—Usually used with RSN (WPA2)
• TKIP—Usually used with WPA
• WEP-104—Used with dynamic WEP
• WEP-40—Used with dynamic WEP
12 Click Next.
13 If you selected Static WEP in
• For each key (up to four), type the key value in the corresponding key box.
• By default, data in unicast and multicast packets are encrypted using WEP key 1. To use
another key for either type of packet, select the key number in the WEP Unicast Key Index or
WEP Multicast Key Index box.
14 Click Next.
15 Select or type the name of the VLAN to place clients in.
Note. Clients are placed in this VLAN regardless of any other VLAN assignment.
For example, if the VLAN-Name attribute assigns the user to another VLAN, the
switch nonetheless places the user in the VLAN you specify here.
16 Click Next.
The ACEs (ACL rules) that WLAN Management Software will configure for the Web-Portal service are
listed. The ACEs are required to allow DHCP traffic while blocking all other traffic while a user is being
authenticated. These ACEs are used only during authentication. After the user is authenticated, the ACEs
are not used.
If you need to add ACEs, use the following procedure. Otherwise, go to
a
Click Next.
b
To add an ACE, click Add Rule. WLAN Management Software adds an ACE to the end of the list.
The ACE matches on all source and destination IP addresses and denies them.
To modify an ACE, select the part of the ACE you want to modify, and edit or select the new value.
(For information about ACE settings, see
NN47250-102 (320666-G Version 02.01)
step 7, specify WEP keys. Otherwise, click Next and go to
"Viewing and Configuring ACLs" (page
step 10.
step 15.
step 17.
208).)