Modifying Access Rules - Nortel 2350 Reference Manual

244 Configuring Wireless Parameters
If the access type is Web Portal, the ACEs (ACL rules) that WLAN Management Software will
configure for the Web-Portal service are listed. The ACEs are required to allow DHCP traffic
while blocking all other traffic while a user is being authenticated. These ACEs are used only
during authentication. After the user is authenticated, the ACEs are not used.
If you need to add ACEs, continue with this step. Otherwise, click Next and go to
Access Rules"
• To add an ACE, click Add Rule. WLAN Management Software adds an ACE to the
end of the list. The ACE matches on all source and destination IP addresses and
denies them.
• To modify an ACE, select the part of the ACE you want to modify, and edit or select
the new value. (For information about ACE settings, see
ACLs" (page
Caution!
be present and the capture option must be used with the rule. If the rule does not
have the capture option, the Web Portal user never receives a login page.
11 To modify access rules, click Next and go to
Finish.

Modifying Access Rules

1
If you have not already done so, access the Access Rules Configuration page for the service
profile:
a
Select the service profile in the Wireless Service Profiles table.
b
Select one of the following in the Task List panel:
❍
❍
❍
❍
❍
c
If you selected Access Rules, go to
wizard until you reach the Access Rules Configuration page.
2
To create a new rule, click Create.
• Specify the user wildcard or MAC address wildcard. (For syntax information, see
"Access Rules" (page
• To modify an existing rule, select the rule and click Properties.
(For information, see the procedure for configuring the type of service profile you are
modifying. For example, if you selected an 802.1X profile, see
Wireless Service" (page
3
When you finish making changes, click Finish to save them and close the wizard.
NN47250-102 (320666-G Version 02.01)
or click Finish to save the changes and close the wizard.
208).)
Do not change the deny rule at the bottom of the ACL. This rule must
802.1X Access
MAC Access (used for voice)
Web Portal Access
Open Access
Access Rules
224).)
226).)
"Viewing and Configuring
"Modifying Access Rules". Otherwise, click
step 2. Otherwise, click Next to advance through the
"Configuring an 802.1X
"Modifying