Wizard; Creating A New Wss Based On A Configured Switch In The Network Plan - Nortel 2350 Reference Manual

Creating a WSS Using the Create WLAN—Security Switch Wizard
1
Select the Configuration tool bar option.
2
In the Organizer panel, select the network plan name.
3
In the Task List panel, select Create WLAN—Security Switch.
4
Go to "Using the Create WLAN—Security Switch Wizard" (page

Creating a New WSS Based on a Configured Switch in the Network Plan

You can copy and modify a switch that is already in the network plan, by copying and pasting the switch in the
Organizer panel.
1
Select the Configuration tool bar option.
2
In the Organizer panel, select the switch you want to copy, then right-click on the switch and select Copy.
3
Right-click and select Paste. The WLAN—Security Switch Properties wizard appears.
4
In the WSS Name box, type the name of the WSS (1 to 256 alphanumeric characters, with no spaces or
tabs).
Note.
unique name.
5
Type the switch's serial number in the Serial Number box.
6
To modify the system IP address and VLAN, select them from the System VLAN/IP drop-down list.
The system IP address determines the interface or source IP address WSS Software uses for system tasks,
including the following:
• Mobility Domain operations
• Topology reporting for dual-homed APs
• Default source IP address used in unsolicited communications such as AAA accounting reports
and SNMP notifications
7
Click Management Interface.
8
To enable the switch to be managed by WLAN Management Software, select Managed. Until this option
is selected, you cannot deploy the switch configuration you create in WLAN Management Software to
the actual switch in the network.
Note.
in the Task List panel.
Within a network plan (and all Mobility Domains), each WSS must have a
This option also enables the Launch Telnet and Launch Browser options
Nortel WLAN—Management Software 2300 Series Reference Guide
Configuring WSS System Parameters 161
164).