Nortel 2350 Reference Manual page 240
Wlan-management software 2300 series
Hide thumbs
Also See for 2350:
- User manual (218 pages) ,
- Installation and basic configuration manual (172 pages) ,
- Quick start manual (44 pages)
Table of Contents
Advertisement
240 Configuring Wireless Parameters
•
802.11b—2.0
•
802.11g—2.0
•
Multicast rate—Data rate at which the radio sends multicast frames. The valid rates depend on the radio
type and are the same as the mandatory rates. The default is Automatic, which sets the multicast rate to
the highest rate that can reach all clients connected to the radio.
•
Mandatory rates—Set of data transmission rates that clients are required to support in order to associate
with an SSID on an AP radio. A client must support at least one of the mandatory rates. These rates are
advertised in the basic rate set of 802.11 beacons, probe responses, and reassociation response frames
sent by AP radios.
Management frames sent by AP radios use one of the specified mandatory rates.
The valid rates depend on the radio type:
•
802.11a—6.0, 9.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
•
802.11b—1.0, 2.0, 5.5, 11.0
•
802.11g—1.0, 2.0, 5.5, 6.0, 9.0, 11.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
The default depends on the radio type:
•
802.11a—6.0, 12.0, and 24.0
•
802.11b—1.0, and 2.0
•
802.11g—1.0, 2.0, 5.5, and 11.0
•
Supported rates—Rates that are not mandatory but that the radio can nonetheless use to send data. By
default, all valid rates that are not mandatory are still supported.
•
Disabled rates—Data transmission rates that AP radios will not use to transmit data. This setting applies
only to data sent by the AP radios. The radios will still accept frames from clients at disabled data rates.
By default, none of the data rates are disabled.
Note. All rate settings apply specifically to data rates used by radios for transmission.
Radios can accept frames from a wireless client at any valid rate.
1
Select the Configuration tool bar option.
2
In the Organizer panel, click the plus sign next to the WSS.
3
Click the plus sign next to Wireless.
4
Select Wireless Services.
The service profiles appear in the Content panel. Each row in the table shows settings for an
individual service profile.
5
Select the Service Profile and click Properties.
6
Click the Rate Configuration tab, click 802.11g.
For the 12.0 Transmission Rate, change the Rate Attribute to Mandatory. Leave the other Rate
Attributes as-is
7
Click OK.
NN47250-102 (320666-G Version 02.01)
Advertisement
Table of Contents
