Changing The Country Code - Nortel 2350 Reference Manual

70 Working with Network Plans
8
In the Telnet Port Number box, specify the port number for Telnet service.
9
In the HTTP Port Number box, specify the port number for HTTP service.
10 Click Next.
11 In the AP Model drop-down list, select one of the following:
• AP (Dual Radio)—802.11a and 802.11b or 802.11b/g
• AP (Single Radio)—802.11a, 802.11b, or 802.11g
12 In the Radio Type drop-down list, select one of the following: 11a, 11b, 11g.
The choices available depend on the selection you made in
13 Click Next.
14 Verify the radio slot number and radio type.
For a dual-radio access point, 802.11b/g radios have a slot number of 1. 802.11a radios have a slot
number of 2.
15 In the Channel Number list, select the channel number for the radio.
16 In the Transmit Power box, specify the transmit power for the radio.
17 To enable the radio, select Enabled.
Note.
channel allocation.
18 In the SSID box, type the service set identifier (SSID) for the radio.
19 In the MAC Address box, type the MAC address of the radio.
20 In the Antenna Gain list, select the antenna gain for the radio.
21 If the access point has only one radio, click Finish. Otherwise, go to
22 Click Next. The Radio A page appears.
23 Repeat
step 14
24 Click Finish to save the changes.
25 To place the AP on a floor plan, see

Changing the Country Code

The country code determines the valid radio types as well as channel numbers and power settings for AP radios. The
country code is one of the parameters you set when you create a network plan. If you need to change a plan's country
code, use the following procedure. Be sure to select the country code for the country in which the AP will be operated. It
is a violation of regulatory laws to set the country code to a country that is different than the actual country that the AP is
operating in.
1
Select the Configuration tool bar option.
2
In the Organizer panel, select the network plan name.
NN47250-102 (320666-G Version 02.01)
The access point's radio must be enabled in order to be considered in
through step 20 for the 802.11a radio.
"Moving a Third-Party AP Icon to its Floor Location" (page
step 11.
step 22.
132).