Example 4: Deployment Site Has Dhcp But Local Dns Domain Differs From Corporate Dns Domain - Nortel 2350 Reference Manual

6
Enable the WSS Software DNS client:
WSS# set ip dns server enable
success: change accepted.
7
Enable the auto-config option:
WSS# set auto-config enable
success: change accepted.
8
Save the configuration changes:
WSS# save config
success: configuration saved.
9
Power off or restart the switch.
Example 4: Deployment Site has DHCP but Local DNS Domain differs
from Corporate DNS Domain
The deployment site in this example has a DHCP server, so the switch's DHCP client is enabled. Static IP address and
default router (gateway) information are not required. The site also has a local DNS server. However, the local DNS
domain name is different from the corporate DNS domain name where WLAN Management Software Services are
located. The static DNS configuration on the switch overrides the DNS configuration from the DHCP server.
1
Configure a VLAN:
WSS# set vlan 1 port 7
success: change accepted.
2
Enable the DHCP client on VLAN 1:
WSS# set interface 1 ip dhcp-client enable
success: change accepted.
3
Configure the default DNS domain name:
WSS# set ip dns domain examplecorp.com
Domain name changed
4
Configure DNS server information:
WSS# set ip dns server 192.168.11.2
5
Enable the WSS Software DNS client:
WSS# set ip dns server enable
success: change accepted.
6
Enable the auto-config option:
WSS# set auto-config enable
success: change accepted.
7
Save the configuration changes:
WSS# save config
success: configuration saved.
Nortel WLAN—Management Software 2300 Series Reference Guide
Configuring WSSs Remotely 315