Service Profile Tab; Wpa, Rsn Tab; Static Wep Tab - Nortel 2350 Reference Manual

• Static WEP
• Authorization Attributes
• Broadcast Settings
• Radio Profile Selection
• Voice Configuration
• Client Timeout
• Rate Configuration
• SODA
• Web Portal

Service Profile Tab

The following settings on the Service Profiles tab are explained in the sections on the service profile wizards:
• Name
• SSID
• SSID Type
• Beacon
• Fall Through Access
For descriptions, see Table 1 on page
The Service Profile tab also has the following settings:
• Web-Portal ACL—Specifies the name of the ACL WSS Software uses to filter a Web-Portal user's traffic
during authentication. This option is applicable only to the Web Portal fallthru authentication type.
• Web Portal Page—Specifies the name of a custom login page served to clients users when accessing the
Web Portal SSID.
• Keep Initial VLAN—When enabled, this option prevents a user from being reassigned to a new VLAN
after roaming from one WSS to another. (For more information, see the "Keeping Users on the Same
VLAN Even After Roaming" section of the "Configuring AAA for Network Users" chapter in the
WLAN Security Switch 2300 Series Configuration
All the settings on the Service Profiles tab are explained in the sections on the service profile wizards. For
descriptions, see Table 1 on page

WPA, RSN Tab

Most of the settings on the WPA, RSN tab are explained in the sections on the service profile wizards.
The TKIP Countermeasures Time specifies how many ms the switch will hold down traffic on the SSID if
more than one Message Integrity Check (MIC) error occurs within a one-minute interval. You can specify
from 0 to 60000 (one minute). The default is 60000.

Static WEP Tab

All but one of the settings on the Static WEP tab are explained in the sections on the service profile wizards.
222.
Guide.)
222.
Nortel WLAN—Management Software 2300 Series Reference Guide
Configuring Wireless Parameters 237
Nortel