Installation Log File - Nortel 2350 Reference Manual

Note.
switches, you must use port 443 for WMS Services. When a switch requests its
configuration from WMS Services, it sends the request to port 443.
7
Change the service port numbers if needed, then click Next.
Note.
change them at any time from within WLAN Management Software. (See
"Changing Service Settings" (page
The installer displays the memory limitations for the client and for WMS Services (if applicable). By
default, up to 512 MB of RAM are allocated for each. To change this amount for the client, for WMS
Services, or for both, select the new amount(s), then click Next.
When installation is complete, you see a page similar to the following, which reports that the installation
was successful and identifies the directory in which WLAN Management Software was installed.
8
Click Done.
See "Getting Started" (page 53)

Installation Log File

During installation, an installation log file, WLAN Management Software_InstallLog.log, is created and placed in the
WLAN Management Software installation folder. Double-click the log file's icon to read the log file. Have this log file
available if you need to contact the Nortel Enterprise Technical Support (NETS) about an installation problem.
If you plan to use the remote configuration option to configure new
If you don't change the port numbers here but you need to later, you can
for more information on getting started with WLAN Management Software.
Nortel WLAN—Management Software 2300 Series Reference Guide
Installing WLAN Management Software 35
464).)