Specifying Default Device Settings For The Coverage Area - Nortel 2350 Reference Manual

122 Planning the Nortel WLAN 2300 System

Specifying Default Device Settings for the Coverage Area

You can optionally specify the WSS or AP models that WLAN Management Software uses when calculating the devices
to include in the coverage area.
1
To change the WSS model, select the model from the WSS Model list.
2
To change the default AP model, select the model from the Default AP Model list.
Note. If this is a shared area (more than one radio technology), only dual-radio
models are listed. If the area is not shared, all models are listed.
3 To change the AP connection type, select the type from the AP Connection Type list:
• Direct—APs are directly attached to dedicated WSS ports.
• Distributed—APs can be indirectly attached through intermediate Layer 2 or Layer 3 devices.
NN47250-102 (320666-G Version 02.01)