Nortel 2350 Reference Manual page 118

118 Planning the Nortel WLAN 2300 System
3 In the Create area under Coverage Area, click one of the icons and draw the object as described in the
following table.
Object
(polygon)
The Create Coverage Area wizard appears.
NN47250-102 (320666-G Version 02.01)
Action
Diagonally drag the cursor over the area where you want the
circle to appear.
(circle)
Diagonally drag the cursor over the area where you want the
square to appear.
(square)
1. Click at a vertex, and drag the cursor to the next vertex.
2. Click again, and drag the cursor until the parallelogram
takes the shape you want.
(parallelogram)
3. Click to finish.
1. Click at a vertex, then move the cursor to the next vertex.
2. Repeat until the polygon takes the shape you want.
For a polygon with n sides, click n-1 additional times at the
vertices. For example, to draw a 7-sided polygon, click at 6
vertices.
3. At the last vertex before completing the shape, Right-click
to complete the polygon.
1. Click at the start of the line.
2. Drag the cursor to the end of the line.
3. Click to finish.
(line)
1. Click to exit Insert Area mode.
(cursor)