Configuring A Directly Connected Ap - Nortel 2350 Reference Manual

254 Configuring Wireless Parameters
7
In the Fingerprint box, type the 16-digit hexadecimal number of the AP's encryption fingerprint. Use
either of the following formats:
• 11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff:00
• 1122:3344:5566:7788:99aa:bbcc:ddee:ff00
An AP's fingerprint is the hash value of the AP's public encryption key. The fingerprint is displayed on a
label on the back of the AP, and is labeled RSA key. If the AP is already installed and operating, use the
CLI command show dap status command to display the fingerprint.
Note. The fingerprint is used for secure communication between the WSS and
the AP, and applies only to Distributed APs.
8
Click Next.
9
Select the AP model from the AP Model list.
10 To select the radio type for a single-radio model, click the AP Radio Type box and select the radio type
from the list:
• 11b—802.11b only
• 11g—802.11b/g
11 Click Next.
12 Configure the radios:
a
To enable the radio, select Enabled.
b
In the Radio Profile list, select the profile to which the radio belongs. (For more information, see
"Viewing and Configuring Radio Profiles" (page
c
In the Channel Number list, select the channel number for the radio.
Note. If RF Auto-Tuning for channel configuration is enabled, setting this value
has no effect. The channel number is controlled by RF Auto-Tuning.
d
In the Transmit Power box, specify the transmit power for the radio.
Note. If RF Auto-Tuning for power configuration is enabled, setting this value has
no effect. The power level is controlled by RF Auto-Tuning.
e
If the AP has two radios, click Next and repeat this step for the other radio. Otherwise, go to
13 Click Finish.

Configuring a Directly Connected AP

APs contain radios that provide networking between your wired network and IEEE 802.11 wireless users. An AP can
connect to the wired network through a direct 10/100 Ethernet connection to an WSS or indirectly through other Layer 2
or Layer 3 wired networking devices. Configure an AP port for each directly connected AP.
NN47250-102 (320666-G Version 02.01)
245).)
step 13.