Adjusting The Scale Of A Drawing; Adjusting The Origin Point - Nortel 2350 Reference Manual

Figure 2: Floor Plan After Cropping

Adjusting the Scale of a Drawing

If you imported a DWG or DXF drawing, you might need to adjust the scale of the drawing because the units used in
these drawings might not have a one-to-one correspondence to meters and feet. To adjust the scale of the drawing, you
draw a line between two points of known distance and adjust the measurement.
To adjust the scale
1 Display the floor plan in the Content panel.
2 Click
3 Drag to create a line between two points. A dialog box appears.
4 In the dialog box, type the actual distance between the two points.
5 Click OK.

Adjusting the Origin Point

WLAN Management Software uses a building's origin point to understand what is above or below a given floor. When
calculating RF coverage, WMS needs to understand where APs on adjacent floors are located so that WMS can take RF
from those APs into account when assigning channels.
on the toolbar.
Nortel WLAN—Management Software 2300 Series Reference Guide
Planning the Nortel WLAN 2300 System 91