Nortel 2350 Reference Manual page 186

186 Configuring WSS System Parameters
a
Select the Configuration tool bar option.
b
In the Organizer panel, click the plus sign next to the WSS.
c
Click the plus sign next to System.
d
Select Management Services.
e
In the Task List panel, select Notification Target.
2
Specify the target ID.
3
Type the IP address of the target.
4
Specify the protocol port on which the target listens for SNMP notifications. The default is 162.
5
Click Next.
6
Select the notification profile that will use this target.
To view the profile's notification types, or to enable or disable notification types:
a
Click Properties.
b
Click the checkbox next to each notification type you want to enable disable. To enable or disable all
notification types, click the Enable checkbox at the top of the list.
To create a new profile:
a
Select Create new Notification Profile and click Next.
b
In the Profile Name box, type the name of the notification profile. The name can be 1 to 32
alphanumeric characters, with no spaces or tabs.
c
Click Next.
d
Click the checkbox next to each notification type you want to enable. To enable all notification
types, click the Enable checkbox at the top of the list.
e
Click Next.
7
From the Security Model drop-down list, select the SNMP version.
8
For USM (SNMPv3), select the security type:
• Unsecured—SNMP message exchanges are not secure. This is the default, and is the only value
supported for SNMPv1 and SNMPv2c. (This security level is the same as the noAuthNoPriv
level described in SNMPv3 RFCs.)
• Authenticated—SNMP message exchanges are authenticated but are not encrypted. (This
security level is the same as the authNoPriv level described in SNMPv3 RFCs.)
• Encrypted—SNMP message exchanges are authenticated and encrypted. (This security level is
the same as the authPriv level described in SNMPv3 RFCs.)
9
Click Next.
• If you selected V1 or V2C in
• If you selected USM in
10 For SNMPv1 or SNMPv2c, select or create the SNMP community string.
If a community string with access type read-write-notify, read-notify, or notify-only is already
configured, you can select it. Otherwise, you must create a new one. You also can create a new
community string even if one is already configured.
To create a new SNMP community string:
NN47250-102 (320666-G Version 02.01)
step 7, go to step 10.
7, go to step 12.
step