Connecting The Ex4500 To Power; Connect Earth Ground To An Ex Series Switch - Juniper EX4500 Hardware Manual

Reasons to mount the switch in a recessed position include:
You are mounting the switch in a cabinet and the cabinet doors will not close completely unless the
switch is recessed.
The switch you are mounting has an uplink module with transceivers installed in it—the transceivers in
the uplink module ports protrude from the front of the switch.
To mount the switch in a recessed position on four posts, follow the instructions in
Switch on Four Posts in a Rack or Cabinet" on page
NOTE: You cannot mount the EX4500 switch in a recessed position in a two-post rack or cabinet.

Connecting the EX4500 to Power

IN THIS SECTION

Connect Earth Ground to an EX Series Switch | 121

Connecting AC Power to an EX4500 Switch | 128
Connecting DC Power to an EX4500 Switch | 131
Connect Earth Ground to an EX Series Switch
IN THIS SECTION
Parts and Tools Required for Connecting an EX Series Switch to Earth Ground | 122
Special Instructions to Follow Before Connecting Earth Ground to an EX Series Switch | 126
Connecting Earth Ground to an EX Series Switch | 127
117.
"Mounting an EX4500
121