Juniper EX4500 Hardware Manual page 185

Table 60: Chassis Viewer for EX8216 Switches (continued)
Field
Interface status
Slot numbers
Temperature
Fan status
Power supplies
LCD panel
Rear View
SF modules
Description
In the image, click any line card or RE module to display the front view of the selected
component. In the image, the colors listed below denote the interface status:
Green—Interface is up and operational.
Yellow—Interface is up but is nonoperational.
Gray—Interface is down and nonoperational.
Mouse over the interface (port) to view more information.
You can view status for the following ports on the RE module:
USB port—Indicates the USB port for the switch.
NOTE: We recommend that you use USB flash drives purchased from Juniper Networks
for your EX Series switch.
Auxiliary port—This port is unavailable.
Management (me0) port—The management port is used to connect the switch to a
management device for out-of-band management.
Console port—The console port is used to connect the switch to a management console
or to a console server. (You might do this for initial switch configuration.)
Slots on the switch are labeled, from the top of the switch down:
RE0 (RE module)
RE1 (RE module)
0–15 (line cards)
The active slots contain a gray temperature icon. Mouse over the icon to display temperature
information for the slot.
Mouse over the fan tray icon to display consolidated information about the fans.
Mouse over the power supply icons to display name, status, and description information.
LCD panel configured for the LEDs on the ports. Mouse over the icon to view the current
character display.
Mouse over the SF module icons in their respective slots to display information. Slots are
numbered SF7–SF0, from left to right.
185