Maintaining Ex4500 Virtual Chassis Cable; Disconnecting A Virtual Chassis Cable From An Ex4500 Switch - Juniper EX4500 Hardware Manual

Figure 67: Installing the Virtual Chassis Module in an EX4500 Switch
NOTE: If you have a Juniper J-Care service contract, register any addition, change, or upgrade
of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
result in significant delays if you need replacement parts. This note does not apply if you replace
existing components with the same type of component.

Maintaining EX4500 Virtual Chassis Cable

IN THIS SECTION

Disconnecting a Virtual Chassis Cable from an EX4500 Switch | 221

Connecting a Virtual Chassis Cable to an EX4500 Switch | 223
Disconnecting a Virtual Chassis Cable from an EX4500 Switch
The Virtual Chassis module has two dedicated Virtual Chassis ports (VCPs) that can be used to interconnect
the EX4500 switch with EX4200 switches or EX4500 switches to form a Virtual Chassis. The Virtual
Chassis module is installed on the rear side of the switch chassis. Use the procedure described in this topic
to disconnect a Virtual Chassis cable from the dedicated VCP port on a Virtual Chassis module.
. Failure to do so can
221