Ac Power Cord Specifications For An Ex4500 Switch - Juniper EX4500 Hardware Manual

AC Power Cord Specifications for an EX4500 Switch

Each AC power supply for the EX4500 switch has a single AC appliance inlet located on the power supply
that requires a dedicated AC power feed. Most sites distribute power through a main conduit that leads
to frame-mounted power distribution panels, one of which can be located at the top of the rack that houses
the switch. An AC power cord connects each power supply to the power distribution panel.
Each detachable AC power cord is 2.5 meters (approximately 8 feet) long. The appliance coupler end of
the cord inserts into the AC appliance inlet on the faceplate of the AC power supply. The coupler type is
C19 as described by the International Electrotechnical Commission (IEC) standard 60320. The plug end
of the power cord fits into the power source outlet that is standard for your geographical location.
NOTE: In North America, AC power cords must not exceed 4.5 meters (approximately 15 feet)
in length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and
210-52 and Canadian Electrical Code (CEC) Section 4-010(3) standards. The cords shipped with
the switch are in compliance with these standards.
Table 18 on page 62 lists the AC power cord specifications for an EX4500 switch for the countries and
regions listed in the table.
Table 18: AC Power Cord Specifications for an EX4500 Switch
Electrical
Country/Regi o n Specifications
Argentina 250 VAC, 16 A, 50 Hz
Australia 250 VAC, 15 A, 50 Hz
Brazil 250 VAC, 16 A, 50 Hz
Juniper Model
Plug Standards Number
IRAM Type RA/3/20 CBL-EX-PWR-C19-AR
AS/NZS 3112 Type CBL-EX-PWR-C19-AU
SAA/3/15
NBR 14136: 2002 Type CBL-EX-PWR-C19-BR
BR/3/20
Graphic
No graphic available
No graphic available
62