Connecting Ac Power To A Qfx10002 - Juniper QFX10002 Hardware Manual

SEE ALSO
Console Port Connector Pinout Information
Configuring Junos OS to Set Console and Auxiliary Port Properties

Connecting AC Power to a QFX10002

Ensure that you have a power cord appropriate for your geographical location available to connect AC
power to the switch.
Before you begin connecting AC power to the switch:
• Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD)
damage, (see "Prevention of Electrostatic Discharge Damage" on page
• Ensure that you have connected the switch chassis to earth ground, see
to Ground" on page 105.
• Install the power supply in the chassis following the instructions in
QFX10002" on page
The power supply in a QFX10002 is a hot-removable and hot-insertable field-replaceable unit (FRU).
After removing the power cord from an individual power supply, you can remove and replace it without
powering off the switch or disrupting switch functions.
NOTE: Each power supply must be connected to a dedicated power source outlet.
To connect AC power to a QFX10002:
1. Attach the grounding strap to your bare wrist and to a site ESD point.
2. Ensure that the power supplies are fully inserted in the chassis and the latches are secure.
3. Locate the power cord or cords shipped with the switch; the cords have plugs appropriate for your
geographical location. See
WARNING: Ensure that the power cord does not block access to device components
or drape where people can trip on it.
4. Connect each power supply to the power sources. Insert the coupler end of the power cord into the
AC power cord inlet on the AC power supply faceplate (see
128.
"QFX10002 AC Power Specifications" on page 52
189).
"Connecting the QFX10002
"Installing a Power Supply in a
.
Figure 40 on page 111).
110