Juniper EX4500 Hardware Manual page 182

Table 57: Chassis Viewer for EX4650 Switches (continued)
Field
USB port
Fan Tray
Power supply
Table 58: Chassis Viewer for EX6210 Switches
Field Description
Front View
Temperature Mouse over the temperature icon to display the temperature of the CB or line card.
Interface status Select the CB or line card.
In the image, the colors listed below denote the interface status:
Mouse over the interface (port) to view more information.
You can view status for the following ports on the SRE module:
CBs support 4 SFP+ uplink ports. Mouse over the interface on the CB for more information.
For SFP and SFP+ ports, the interfaces appear dimmed if no transceiver is inserted. The chassis
viewer displays Transceiver not plugged-in when you mouse over the port icon.
Description
Indicates the USB port for the switch.
NOTE: We recommend that you use USB flash drives purchased from Juniper
Networks for your EX Series switch.
Mouse over the fan tray icons to display name, status, and description information.
Mouse over the power supply icon to display name, status, and description
information.
Green—Interface is up and operational.
Yellow—Interface is up but is nonoperational.
Gray—Interface is down and nonoperational.
USB port—Indicates the USB port for the switch.
NOTE: We recommend that you use USB flash drives purchased from Juniper Networks
for your EX Series switch.
Management (me0) port—The management port is used to connect the switch to a
management device for out-of-band management. There are 2 management ports: fiber and
copper. The same status is displayed for both the me0 ports.
Console port—The console port is used to connect the switch to a management console or
to a console server. (You might do this for initial switch configuration.)
182