Juniper EX4500 Hardware Manual page 226

6. To remove an SFP, SFP+, XFP, or a QSFP+ transceiver:
a. By using your fingers, pull open the ejector lever on the transceiver to unlock the transceiver.
CAUTION:
ejector lever completely until you hear it click. This prevents damage to the
transceiver.
b. Grasp the transceiver ejector lever and gently slide the transceiver approximately 0.5 in. (1.3 cm)
straight out of the port.
CAUTION:
connector pins at the end of the transceiver.
Figure 70: Remove a QSFP+ Transceiver
1 Ejector lever
—
To remove a CFP transceiver:
a. Loosen the screws on the transceiver by using your fingers.
b. Grasp the screws on the transceiver and gently slide the transceiver approximately 0.5 in. (1.3 cm)
straight out of the port.
CAUTION:
connector pins at the end of the transceiver.
7. By using your fingers, grasp the body of the transceiver and pull it straight out of the port.
Before removing the transceiver, make sure that you open the
To prevent ESD damage to the transceiver, do not touch the
To prevent ESD damage to the transceiver, do not touch the
226