Virtual Chassis Module In Ex4500 Switches - Juniper EX4500 Hardware Manual

Table 6: LCD Panel Menu Options in EX4500 Switches (continued)
Menu

Virtual Chassis Module in EX4500 Switches

The Virtual Chassis module is installed horizontally on the rear panel of an EX4500 switch chassis. The
Virtual Chassis module has two dedicated Virtual Chassis ports (VCPs) that can be used to interconnect
the EX4500 switch with an EX4200 switch or an EX4500 switch in a Virtual Chassis configuration. The
module is an offline field-replaceable unit (FRU).
NOTE: The Virtual Chassis module is supported on EX4500 switches in Junos OS Releases 11.1
and later.
The Virtual Chassis module comes preinstalled in the switch chassis in the EX4500-40F-VC1-FB,
EX4500-40F-VC1-BF, and EX4500-40F-VC1-DC switch models. You must order it separately for all other
switch models. See "EX4500 Switch Models" on page
NOTE: Virtual Chassis cables and Virtual Chassis cable connector retainers are not part of the
EX4500 switch's shipping configuration. If you want to purchase these, you must order them
separately.
Description
For information about EZSetup, see
Series Switch (J-Web Procedure)" on page
Press Menu to go to the next option in the Maintenance menu.
EXIT MAINT MENU?—Choose one of the following:
Press Enter to exit the Maintenance menu.
Press Menu to return to the SYSTEM HALT option.
You can disable the Maintenance menu or the options in the Maintenance
menu in the LCD panel. See
(CLI Procedure)" on page 157.
25.
"Connecting and Configuring an EX
153.
"Configuring the LCD Panel on EX Series Switches
44