Rj-45 Management Port Connector Pinout Information - Juniper EX4500 Hardware Manual

CAUTION:
has not been tested by Juniper Networks. The use of any unsupported USB memory
product could expose your EX Series switch to unpredictable behavior. Juniper
Networks Technical Assistance Center (JTAC) can provide only limited support for
issues related to unsupported hardware. We strongly recommend that you use only
supported USB flash drives.
All USB flash drives used on EX Series switches must have the following features:
USB 2.0 or later.
Formatted with a FAT or MS-DOS file system.
If the switch is running Junos OS Release 9.5 or earlier, the formatting method must use a primary boot
record. Microsoft Windows formatting, by default, does not use a primary boot record. See the
documentation for your USB flash drive for information about how your USB flash drive is formatted.

RJ-45 Management Port Connector Pinout Information

Table 29 on page 93 provides the pinout information for the RJ-45 connector for the management port
on Juniper Networks devices.
Table 29: RJ-45 Management Port Connector Pinout Information
Pin Signal
1 TRP1+
2 TRP1—
3 TRP2+
4 TRP3+
5 TRP3—
6 TRP2—
7 TRP4+
8 TRP4—
Any USB memory product not listed as supported for EX Series switches
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
Transmit/receive data pair 4
93