Juniper EX4500 Hardware Manual page 212

6. Position your fingers under the module as shown in
and eject the module.
NOTE: Do not use the captive screws to pull the module out from the chassis. Pull from
underneath the front edge of the module.
7. Using both hands, gently slide the intraconnect module halfway out of the chassis.
8. Place one hand under the module to support it and slide it completely out of the chassis.
9. Place the intraconnect module in an antistatic bag or on an antistatic mat placed on a flat, stable surface.
Promptly install the replacement intraconnect module. See
Switch" on page 213.
Figure 64: Removing an Intraconnect Module from an EX4500 Switch
NOTE: If you have a Juniper J-Care service contract, register any addition, change, or upgrade
of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
result in significant delays if you need replacement parts. This note does not apply if you replace
existing components with the same type of component.
Figure 64 on page 212
Press on both sides of the chassis
to disengage the Intraconnect module.
(Don t pull on the captive screws!)
and pull outwards to unseat
"Installing an Intraconnect Module in an EX4500
Captive screw
. Failure to do so can
212