Installing A Virtual Chassis Module In An Ex4500 Switch - Juniper EX4500 Hardware Manual

Figure 66: Removing the Virtual Chassis Module from an EX4500 Switch
NOTE: If you have a Juniper J-Care service contract, register any addition, change, or upgrade
of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
result in significant delays if you need replacement parts. This note does not apply if you replace
existing components with the same type of component.

Installing a Virtual Chassis Module in an EX4500 Switch

The Virtual Chassis module is installed horizontally on the rear panel of the switch. See
EX4500 Switch" on page
NOTE: The Virtual Chassis module is supported on EX4500 switches in Junos OS Releases 11.1
and later.
Press on the outside edges of the module slot,
then pull the Virtual Chassis module straight out.
36. Use the procedure described in this topic to install the Virtual Chassis module.
. Failure to do so can
"Rear Panel of an
218