Installing And Connecting An Ex4500 Switch; Mounting An Ex4500 Switch - Juniper EX4500 Hardware Manual

Installing and Connecting an EX4500 Switch

To install and connect an EX4500 switch:
1. Follow instructions in
2. Mount the switch by following instructions appropriate for your site:
"Mounting an EX4500 Switch on Two Posts in a Rack or Cabinet" on page 115
brackets provided)
"Mounting an EX4500 Switch on Four Posts in a Rack or Cabinet" on page 117
orderable four-post rack-mount kit)
3. Follow instructions in
4. Follow instructions for connecting power as appropriate for your site:
Connecting AC Power to an EX4500 Switch on page 128
5. Perform initial configuration of the switch by following instructions in
EX Series Switch (CLI Procedure)" on page 149
(J-Web Procedure)" on page
6. Set the switch's management options by following the appropriate instructions:
Connect a Device to a Network for Out-of-Band Management on page 140
Connect a Device to a Management Console Using an RJ-45 Connector on page 141

Mounting an EX4500 Switch

You can mount an EX4500 switch:
On two posts in a 19-in. rack or cabinet by using the mounting brackets provided with the switch.
On four posts in a 19-in. rack or cabinet by using the separately orderable four-post rack-mount kit.
In a position recessed 2 in. from the front of a 19-in. rack or cabinet by using the separately orderable
four-post rack-mount kit. You can mount the switch in this recessed position on four-post racks and
cabinets.
The holes in the mounting brackets are placed at 1 U (1.75 in. or 4.45 cm) apart so that the switch can be
mounted in any rack or cabinet that provides holes spaced at that distance.
See the Related Documentation for detailed descriptions of the various rack or cabinet mounting options.
"Unpacking an EX4500 Switch" on page
"Connect Earth Ground to an EX Series Switch" on page
153.
111.
"Connecting and Configuring an
or "Connecting and Configuring an EX Series Switch
(using the mounting
(using the separately
121.
114