Connecting The Ex4500 To External Devices; Connect A Device To A Network For Out-Of-Band Management - Juniper EX4500 Hardware Manual

140

Connecting the EX4500 to External Devices

IN THIS SECTION

Connect a Device to a Network for Out-of-Band Management | 140

Connect a Device to a Management Console Using an RJ-45 Connector | 141
Connect a Device to a Network for Out-of-Band Management
You can monitor and manage these devices by using a dedicated management channel. Each device has
a management port to which you can connect an Ethernet cable with an RJ-45 connector. Use the
management port to connect the device to the management device.
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end. Figure 44 on page 140
shows the RJ-45 connector of the Ethernet cable supplied with the device.
Figure 44: RJ-45 Connector on an Ethernet Cable
To connect a device to a network for out-of-band management (see Figure 45 on page 141):
1. Connect one end of the Ethernet cable to the management port on the device.
2. Connect the other end of the Ethernet cable to the management device.