Juniper EX4500 Hardware Manual page 124

Table 43: Parts Required for Connecting an EX Series Switch to Earth Ground (continued)
Earthing
Terminal
Switch Location
EX3200, Rear panel of
EX3300, the chassis
and
EX3400
EX4200, Left side of
EX4500, the chassis
and
EX4550
EX6210 Rear panel of
the chassis (on
lower left
side)
EX8208 Left side of
the chassis
Grounding
Cable Grounding Lug
Requirements Specifications
14 AWG (2 mm²), Panduit
minimum 90° C LCC10-14BWL or
wire, or as equivalent—
permitted by the not provided
local code
14 AWG (2 mm²), Panduit
minimum 90° C LCC10-14BWL or
wire, or as equivalent—
permitted by the not provided
local code
The grounding Panduit LCD2-14A-Q
cable must be or equivalent
the same gauge —provided
as the power
feed cables and
as permitted by
the local code.
6 AWG Panduit LCD2-14A-Q
(13.3 mm²), or equivalent
minimum 90° C —provided
wire, or as
permitted by the
local code
Screws and Additional
Washers Information
Two For EX3200 Switches,
10-32 x .25 in. see "Special
screws with Instructions to Follow
#10 split-lock Before Connecting
washer— Earth Ground to an
not provided EX Series Switch" on
page 126.
Two #10 flat
washers—
not provided
Two 10-32 See "Special
x .25 in. screws Instructions to Follow
with #10 Before Connecting
split-lock Earth Ground to an
washer— EX Series Switch" on
not provided page 126.
Two #10 flat
washers—
not provided
Two ¼ -20
x 0.5 in. screws
with #¼"
split-washer
—provided
Two #¼" flat
washers—
provided
Two ¼ -20
x 0.5 in. screws
with #¼"
split-washer
—provided
Two #¼" flat
washers—
provided
124