Juniper EX4500 Hardware Manual page 143

NOTE: Interfaces xe-0/0/0 through xe-0/0/39 are the network interface ports. Optional uplink
modules provide four 10-gigabit small form-factor pluggable (SFP+) transceivers (xe-0/1/0
through xe-0/1/3) or four 1-gigabit small form-factor pluggable (SFP) transceivers (xe-0/2/0
through xe-0/2/3). Although you can install only one uplink module, the interfaces for both are
shown below.
When you commit changes to the configuration, a new configuration file is created, which becomes the
active configuration. You can always revert to the factory default configuration. See Reverting to the Default
Factory Configuration for the EX Series Switch.
This topic shows the factory default configuration file of an EX4500 switch:
system {
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
interactive-commands any;
}
}
commit {
factory-settings {
reset-chassis-lcd-menu;
reset-virtual-chassis-configuration;
}
}
}
interfaces {
xe-0/0/0 {
unit 0 {
family ethernet-switching;
}
}
xe-0/0/1 {
unit 0 {
family ethernet-switching;
}
143