Connecting Ac Power To An Ex4500 Switch - Juniper EX4500 Hardware Manual

3. Attach an ESD grounding strap to your bare wrist, and connect the strap to the ESD grounding point
on the switch.
4. Place the grounding lug attached to the grounding cable over the protective earthing terminal. See
Figure 36 on page 128.
Figure 36: Connecting a Grounding Cable to an EX Series Switch
5. Secure the grounding lug to the protective earthing terminal with the washers and screws.
6. Dress the grounding cable and ensure that it does not touch or block access to other switch components
and that it does not drape where people could trip over it.
SEE ALSO
General Safety Guidelines and Warnings | 271
Grounded Equipment Warning | 289

Connecting AC Power to an EX4500 Switch

The AC power supply in an EX4500 switch is a hot-removable and hot-insertable field-replaceable unit
(FRU). After you have installed at least one power supply, you can connect power to the switch.
Grounding lug
Screw
(with split
washer)
128