Juniper EX4500 Hardware Manual page 222

Ensure that you have the following parts and tools available:
Phillips (+) screwdriver, number 2
To disconnect a Virtual Chassis cable from a dedicated VCP on an EX4500 switch (see
1. Loosen the screws on the cable connector retainer by using the screwdriver.
2. Slide the cable connector retainer back.
3. Gently pull the release pull tab on the Virtual Chassis cable connector to release the lock holding the
Virtual Chassis cable connector in the Virtual Chassis port.
4. Gently pull the Virtual Chassis cable connector out of the Virtual Chassis port.
Figure 68: Disconnecting a Virtual Chassis Cable from a Dedicated VCP on a Virtual Chassis Module
NOTE: If you order Virtual Chassis cables separately, you must reuse the cable connector
retainers provided with the original cable or order Virtual Chassis cable connector retainers also
separately.
SEE ALSO
Understanding Virtual Chassis Components
Figure 68 on page 222):
222